Identity Mask Wearable Project

This post continues from the post:

Wearable Project Idea

http://kavasmlikon.wordpress.com/2011/11/21/how-to-make-el-wire-blink/

Drawing based on kavasmlikon's drawing from the link above:

An edited drawing from the one above to add 3 EL Wires:

Materials needed:

1 RedBoard - Programmed with Arduino
DEV-11575

https://www.sparkfun.com/products/11575
 

1 Arduino ProtoShield - Bare PCB
DEV-11665
https://www.sparkfun.com/products/11665

1 9V to Barrel Jack Adapter
PRT-09518https://www.sparkfun.com/products/9518

1 9V Alkaline Battery
PRT-10218https://www.sparkfun.com/products/10218



1 EL Inverter - 3v
COM-10201https://www.sparkfun.com/products/10201





3 TRIAC
COM-09234

https://www.sparkfun.com/products/9234

1 In-line wire 1-to-4 splitter -
ID: 402

https://www.adafruit.com/products/402

3 Resistor 330 Ohm 1/6th Watt PTH
COM-08377https://www.sparkfun.com/products/8377

EL Wire (Min 1ft)
https://www.sparkfun.com/products/11422



Hook-Up Wire (Red and Black)
https://www.sparkfun.com/products/8022



Soldering Equipment



Here are some helpful tutorials:
http://kavasmlikon.wordpress.com/2011/11/21/how-to-make-el-wire-blink/
http://makezine.com/2010/04/27/programming-el-wire-fashion/